Sleep Mode; User Setup - Schwinn MPower Console V2 + Power Owner's Manual

When the Cadence decreases to less than 5 RPM for 3 seconds or more, the console pauses and the LCD Display shows the last workout
data values. If you stay paused for more than 5 minutes, the workout stops and the console goes to Display Results mode.
To set the STAGE time and STAGE distance back to zero for a new stage in the workout, tap the STAGE button. The TOTAL time and TOTAL
distance continue the total measurement for the workout.
To end the workout, push the AVG/END button and hold for 3 seconds. The console goes to Display Results mode.

Sleep Mode

The console automatically goes into Sleep Mode to conserve the battery:
• • •
if there is no activity for 45 seconds after User Setup.
• • •
after Display Results.
• • •
if Workout Mode pauses and there is no activity for 5 minutes.
Push any button to activate the console from Sleep Mode.

User Setup

When the console is in Sleep Mode, push any button to go to User Setup mode.
During User Setup Mode the console collects the necessary user data to calculate and record your workout data. Proximity linking
to the user's HRM or Ant+ watch occurs while in User Setup.
If the console does not find a USB storage device or Ant+ watch, the arrow icons on the console blink. Use the appropriate
instruction for your monitoring equipment.
• • •
USB storage device—install the device in the USB port. When the console senses the device, the USB arrow indicator
stays on.
Ant+ watch—link to the console. Move the watch to 2–4" (5–10 cm) or less from the Ant+ Link Here logo on the console and
hold it there until the arrow stays on. The Ant+ arrow and watch indicators come on when proximity linking is complete.
Ant+ HRM—link to the console. Lean into the console so that the HRM is 7.5–31" (20–80 cm) from the Ant+ Link Here logo,
until the arrow stays on. The Ant+ arrow indicator comes on when proximity linking is complete. If the Ant+ indicator is not
on, the console uses EM 5kHz signal to calculate HRM.
Note: If you have an Ant+ Sport Watch and paired Ant+ HRM, it is only necessary for the the console to link
with the sport watch. However, if you have an Ant+ Sport Watch and EM 5kHz HRM, the console links to
the watch and the HRM.
Operations