Battery Level - Schwinn MPower Console V2 + Power Owner's Manual

Workout Totals
The TOTAL display field shows the total time and distance results at the end of the workout. The Total icon is lit during Workout Mode.
LCD + and – Icons
The + and – (plus and minus) icons on the LCD flash to prompt the user to enter their weight during User Setup Mode. The
icons turn off when not in use.
Keypad
The multi-function keypad lets you set the console measurements for your workout, see and update your workout data, and
examine the console diagnostic messages. Tap any button to activate the console from Sleep Mode. The Operations section of
this manual gives the procedures for using the buttons in each Operations mode. The Backlight button sets your selections in
User Setup Mode and Service Mode.
Alerts
The Console icons and LCD display messages show the status of the console and sensor operations.

Battery Level

The Battery Level icon show the battery level for each component of the console-sensor system. All 4 segments of the icon are on when
the battery level is high. When the battery level is low, only the bottom segment is on. The bottom segment flashes when battery
level is very low.
If the battery level is too low to continue operation, the console display flashes the message "LO batt" and the console goes into Sleep Mode.
If this occurs during a workout, the workout stops and the console display shows the workout results for 10 second. Then the "LO batt" message
shows and the console goes into Sleep Mode.