Schwinn MPower Console V2 + Power Owner's Manual page 12

A43 Pairing
A44
Countdown Timer (Speed Sensor)
A45 Process Status (Speed Sensor)
A46 Process Status (Power Sensor)
9. The Process Status indicator(s) on the console display shows "– – –" while the Pairing operation continues.
If Pairing is completed satisfactorily, the console display shows PASS.
The circuit board inside the Power Sensor cover has 2 color LEDs — 1 green and 1 red. The 2 LEDs come on during
the Pairing operation. While the operation continues satisfactorily, the green LED is on. When Pairing is completed
satisfactorily, both LEDs turn off. If the Pairing operation is not completed satisfactorily, only the red LED stays on.
If the Pairing operation is not completed satisfactorily, the console display shows FAIL. Push the pairing button on the
console (L1). Then do the Device Pairing procedure again.
10. When the Pairing procedure is completed, push the Backlight button to go back to the Service Menu.
If the Pairing operation was not completed satisfactorily, the console display shows the
pairing button on the console (L1). Then do the Device Pairing procedure again.
11. Tap the STAGE or AVG/END button until you see the "– – –" (exit) option in the Service Menu, and push the Backlight button.
12. Install the console and sensors on the bike. Refer to the MPower™ installation guides.
Device Pairing for Multiple Bikes
For Schwinn A.C.™ bikes with MPower™ Consoles in a group setting, make sure to set up Device Pairing for only one bike at a time
to prevent crosstalk between the devices on different bikes.
NOTICE: When you remove the handlebars (with console) to clean them, make sure that you install them again
Recommendation: You can put number labels on the bikes and handlebars to make sure that the Device Pairing stays
A48
A47
A46
on the same bike to keep the Device Pairing correct. If you install the handlebars and console on a
different bike, the console does not read data from the correct sensors.
correct.
A43
A44
A45
A47
Countdown Timer (Power Sensor)
A48 Pairing Indicator
P– – menu option again. Push the