Sony HXCU-D70 Operating Instructions Manual page 24

CCU CONFIGURATION
Page name
Page No.
<MONITOR 2>
C04
<MIC/AUDIO>
C05
<INTERCOM>
C06
24
Setup Menu
Item Settings
LEVEL GATE ---, 1&2, 1, 2, OFF
Y LEVEL1 0 to 108% 49 61
–99 to 99 –25
Y LEVEL2 0 to 108% 74 108
–99 to 99 –25
GATE MARKER ---, ON, OFF
–99 to 99 0
MODULATION ---, ON, OFF
–99 to 99 0
MARKER ON, OFF
4:3, 13:9, 14:9, EU VISTA, VISTA,
CINEMA, FOLLOW DC
CAM MIC GAIN
CH1 ---, 20, 30, 40, 50, 60 dB
CH2 ---, 20, 30, 40, 50, 60 dB
AUDIO OUTPUT
CH1 LEVEL –20, 0, +4 dBu
CH2 LEVEL –20, 0, +4 dBu
SYSTEM I/F 4WIRE, RTS, CLEAR COM
TERMINATION (OFF), ON, OFF
PGM INPUT –20, 0, +4 dBu
Description
1&2: Displays level gate 1&2
1: Displays level gate 1
2: Displays level gate 2
---: Displayed when camera not connected,
video output not set to CAMERA, or video
output is set to CAMERA and GATE MARKER
is ON (display only)
Level gate 1 minimum and maximum detection
levels settings
Level gate 1 zebra range settings
Level gate 2 minimum and maximum detection
levels settings
Level gate 2 zebra range settings
Gate signal display on/off settings
---: Displayed when camera not connected
(display only)
Gate signal level settings
4:3 aspect ratio mask function on/off settings
when EDGE CROP is ON
---: Displayed when camera not connected
(display only)
Mask video level settings
Marker signal on/off settings
Superimposed marker signal selection
Microphone gain settings
Settings vary depending on microphones
---: Displayed when camera not connected
(display only)
Audio output level settings
CH1 output level settings
CH2 output level settings
Intercom interface (D-sub 25-pin) settings
Ω
Connects to a 200 terminator, if ON is
selected while 2-wire intercom interface (RTS
or CLEAR COM) is used
(OFF): Displayed when 4WIRE is selected in
SYSTEM I/F (display only)
PGM input level settings