Ricoh 1018 Operating Instructions Manual page 61

E
Press 0 0 0 0 or 1 1 1 1 until "5. Prog.
Group Dial" is displayed.
F
Press the { { { { OK} } } } key.
G
Display the number of the group
you want to register (1 to 9).
Enter the group number with the
number keys, or search using 0 or
1.
Note
❒ If you make a mistake, press the
{Cancel} key then try again.
❒ If a group has already been
stored, the contents are dis-
played. Press 0 or 1 to select a
group number that is not pro-
grammed, then press the {OK}
key.
❒ If a group is programmed, but
no name is specified, the group
number only is displayed on the
lower line of the display.
H
Specify the destination using one
of the following three methods:
Enter the fax number with the
number keys.
Press a Quick Dial key.
Press the {Speed Dial} key and en-
ter a Speed Dial number.
I
Press the { { { { OK} } } } key.
The destination is programmed.
J
Press the 0 0 0 0 or 1 1 1 1 to select "Add"
or "Exit".
K
Press the { { { { OK} } } } key.
If you selected "Exit", go to step M.
L
Repeat step G G G G to K K K K for all the des-
tinations you want to registered
in the Group.
M
Enter the Group name.
Note
❒ If the Group name is already
registered, it is shown on the
display. If you wish to change
the Group name, p ress the
{Clear/Stop} key and enter an-
other name.
Groups
3
51