Lorex L21Q784 Instruction Manual page 13

4. Title Set – This submenu allows you to change the title of each camera location (up to 8
characters), or remove the titles from the on-screen display.
DISPLAY: Selecting [Y] will enable the camera titles to appear in the on-screen display.
Selecting [N] will remove all titles from appearing in the on-screen display.
CH 1 - 8: Change the titles of each individual camera.
5. Alarm Set – This submenu allows you to enable / disable the camera's PIR Alarm function
by channel, and set alarm duration.
ALARM: Selecting [OFF] disables PIR motion detection from triggering any alarm. Selecting
[OSD] will allow alarms to be triggered, and the letters "AL" will appear on the
screen of the camera location where the alarm is taking place. A third option,
[OSD+BUZZER] will both display "AL" and emit a buzzer sound in the event of an
alarm.
CH 1-8: Set the length of alarm time by channel between 1~59 seconds.
Additionally, you can select the Alarm Input. The default setting is OFF – to activate
the Alarm on a camera, change the setting to N.O (Normally Open).
Note: some non-Lorex PIR motion sensors have a default setting of N.C (normally closed).
In order to activate the alarm on such a PIR motion sensor, change the setting to N.C.
6. Motion Set -This sub-menu allows you to enable / disable the monitor's Pixel-based Motion
Sensing feature by dual channels (eg: Channel 1 / Channel 5, Channel 2 / Channel 6).
MOTION: Selecting [OFF] disables Motion Sensing from triggering any alarm. Selecting
[OSD] will allow alarms to be triggered, and the letters "MD" will appear on the
screen of the camera location where the alarm is taking place. A third option,
[OSD+BUZZER] will both display "MD" and emit a buzzer sound in the event of
an alarm. The setting that you choose will apply to each camera location.
CHANNEL: Select which dual channels will have the Pixel Motion Sensing feature activated.
The Sensitivity level can be set to zero for a channel, which will disable the
Motion Sensing ability for that channel.
SENSITIVITY: Select the level of the Motion Sensing's sensitivity level by channel. Level 05 is
the highest sensitivity, Level 01 is the least sensitive. Level 00 deactivates
Motion Sensing.
AREA: Select the area of the screen where the Pixel Motion Sensing feature will be
active.
Note: a limitation of the Pixel-based Motion Sensing feature is that it cannot detect
motion occurring on a separate Quad Page from the one being viewed.
7. System Set - This sub-menu allows you to configure various preferences on the system.
KEY BUZZER:
LOSS BUZZER: When set to [Y], the system will make a sound when a camera becomes
QUAD LINE:
When set to [Y], the system will make a sound when a key is pressed on
the remote control or on the main panel of the monitor.
disconnected.
Activates and deactivates the border line in Quad mode.
-10-