Toshiba PORTÉGÉ M700 Maintenance Manual page 223

On Battery
The following settings can be changed when the Wake-up on LAN is Enabled.
Enabled
Disabled
NOTE: 1. Do not remove the AC adaptor and battery pack at the same time when you
use this feature. If you do so, data saved by the resume function will be lost.
You must also reset this option.
2. If you have set a password and the computer boots by the Auto Power On
function and Standby is on, the computer will start with the instant security
function enabled. The password = message is not displayed; however, you
must enter the password to use the computer.
3. This option is enabled only once, the setting is reset, after booting up.
(f) Beep Volume
This Option sets up the volume of a Beep sound.
Medium High OFF Low
(g) Diagnostic Mode
This option enables/disables the HW Diagnostic test function.
Enabled
Disabled
(h) USB Sleep and charge
This Option sets up whether a power supply is supplied to a USB device,
when PC is in a Sleep mode state.
Disabled
Enabled Mode1
Enabled Mode2
PORTEGE M700 Maintenance Manual (960-661)
Wake-up on LAN function whenoperating from the battery.
Wake-up on LAN function whenoperating from the battery
(Default).
Disables the HW Diagnostic test function. (Default)
Enables the HW Diagnostic test function.
A power supply is not supplied in a Sleep mode
state. (Default)
A power supply is supplied in a Sleep mode
state.
A power supply is supplied in a Sleep mode
state.
[CONFIDENTIAL]
Tests and Diagnostics
3-97