Connect To The Electricity Supply - Gas - Belling Gas Range Service Manual

INSTALLATION INSTRUCTIONS - GAS PRODUCTS

Connect to the electricity supply - Gas

(mains ignition models only)
Warning: This appliance must be earthed.
The flexible mains lead is supplied
connected to a BS 1363 fused plug, the
plug is fitted with the correct fuse.
Replace only with a fuse of the same
rating and type.
The wires in the mains lead are coloured
in accordance with the following code:
Green and yellow = Earth,
Blue = Neutral,
Brown = Live.
As the colours of the wires in the mains
lead for the appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
1. The wire which is coloured green and
yellow must be connected to the terminal
marked E
(Earth) or coloured Green.
2. The wire which is coloured blue must
be connected to the terminal marked N
(Neutral), or coloured Black.
3. The wire which is coloured brown must
be connected to the terminal marked L
(Live), or coloured Red.
The plug and socket must be accessible
after installation. Should the mains lead of
the appliance ever require replacing, we
recommend that this is carried out by a
qualified electrician who will replace it with
a lead of the same size and temperature
rating.
Important: - ensure that you route all
mains and electrical cables and flexible
tubing well clear of any adjacent heat
source.
Under no circumstances should the mains
electric cable be allowed to come into contact
with the vertical oven flue tubes on the rear of
the appliance.