Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS - GAS PRODUCTS
Windows and permanent vents should
therefore not be blocked or removed
without first consulting a competent gas
installer.
Failure to install appliances correctly is
dangerous and could lead to prosecution.
Whilst every care is taken to eliminate
burrs and raw edges from this product,
please take care when handling - we
recommend the use of protective gloves
during installation.
Moving the cooker
Please note that the weight of this
appliance is approximately 60kg
(unpacked). Take care if the appliance
needs to be lifted during installation
- always use an appropriate method of
lifting.
Do not attempt to move the cooker by
pulling on the doors or handles. Open
the door and grasp the frame of the
cooker, taking care that the door does not
shut on your fingers. Take care to avoid
damage to soft or uneven floor coverings
when moving the appliance. Some
cushioned vinyl floor coverings may not be
designed to withstand sliding appliances
without marking or damage.
Clearances & dimensions
Appliance dimensions
All sizes are nominal - some variation is to
be expected. The 'depth' of the cooker, as
given below, is to the front of the door &
excluding knobs & handles.
depth:
width:
height - lid down:
height - lid raised:
Clearances
No shelf or overhang or cooker hood
should be closer than a minimum of
650mm, but check with cooker hood
manufacturer's recommendations.
The cooker must have a side clearance
above hob level of 90mm up to a height
of 400mm.
This cooker may be fitted flush to base
units. However, for models with side
opening doors, we recommend a side
clearance of 60mm between the cooker
and any side wall.
600mm
600mm
900 - 915mm
1430 - 1445mm
Hide quick links:
Advertisement
Table of Contents
