Toshiba RAV-SM404MUT-E Service Manual page 90

No. Part name
1. Detachment
Ceiling panel
4
NOTE)
Remove the connectors after unlocking the lock of
the housing.
2. Attachment
NOTE)
The panel has directionality.
Therefore mount the panel according to the temporary
bracket and the bracket mounting position.
Procedure
1) Perform works of procedure 1 -1-, 2 -1,
and 3 -1.
2) Remove the flap connector (CN33, White, 5P)
connected to the control P .C. board and then
take off the lead wire from the clamp.
3) Take off screws (M5, 4 pcs.) fixing the ceiling
panel.
4) Push the temporary bracket to inner side to
remove the ceiling panel.
1) Hook the panel to the temporary bracket of
the drain pan of the main body.
2) Tighten the fixing screws. (M5, 4 pcs.)
3) Connect flap connector of the
ceiling panel to the connector
(CN33, White, 5P) of the
control P .C. board.
Hanging
section of tentative
hook of ceiling panel
Push to remove
Washer
based screw
Cable clamp
– 90 –
Remarks
Temporary
bracket
Drain piping
corner
Ceiling panel
Temporary
bracket
Hanging section
of temporary bracket
CN33