Address Setup (Manual Setting From Remote Controller) - Toshiba RAV-SM404MUT-E Service Manual

9-3. Address Setup (Manual Setting from Remote Controller)

In case that addresses of the indoor units will be
determined prior to piping work after wiring work
• Set an indoor unit per a remote controller.
• Turn on power supply.
1
Push + +
SET CL
TEST
simultaneously for 4 seconds or more.
2
(Line address)
Using the temperature setup
set 12 to the CODE No.
3
Using timer time
4
Push button. (OK when display goes on.)
SET
5
(Indoor unit address)
Using the temperature setup
6
Using timer time
7
Push button. (OK when display goes on.)
SET
8
(Group address)
Using the temperature setup
9
Using timer time
Folloer unit.
10
Push button. (OK when display goes on.)
SET
11
Push button.
TEST
Setup completes. (The status returns to the usual stop status.)
2, 5, 8
END
<Operation procedure>
1 2
Indoor unit address → 1
buttons
/
/ buttons, set the line address.
/
/ buttons, set 1 to the line address.
/
0000
/ buttons, set
TEMP.
11
FILTER L L
RESET TEST
1
3 4 5
(Example of 2-lines wiring)
(Real line: Wiring, Broken line: Refrigerant pipe)
Outdoor
1 2 3
1 2 3
Indoor
A B
Line address → 1
Group address → 1
A B
Remote controller
buttons,
13
buttons, set to the CODE No.
14
buttons, set to the CODE No.
0001
to Individual,
ON / OFF
TIMER SET FAN MODE
TIME SAVE A A VENT
SET CL SWING/FIX UNIT LOUVER T
6 7 8 9
– 86 –
Outdoor
1 2 3
1 2 3
Indoor
Indoor Indoor
A B A B
1
1
2
3
2
2
For the above example, perform setting by
connecting singly the wired remote controller
without remote controller inter-unit wire.
Group address
Individual : 0000
Header unit : 0001
In case of group control
Follower unit : 0002
to Header unit, and
3, 6, 9
4, 7, 10
10 11
END
1 2 3
1 2 3 1 2 3
Indoor
A B A B
2 2
1 2
2 2
0002
to