Welch Allyn Atlas Operator's Manual page 19

Atlas Monitor showing NIBP displays, controls and tubing
Setting alarm limits - To set the Systolic and
Diastolic alarm limits, use the
buttons on the right side of the monitor to follow
these steps:
•
Press the button to cycle through
Select
SpO , then Systolic
LO
2
Diastolic and
HI LO
•
Each push of
Select
limit. Stop at the limit you want to set. The
measurement and the
flash, indicating which limit is being
changed.
•
Press the button up or down to raise or
Set
lower the alarm limit. (When you come to
the end of the range, the numbers will stop
changing).
•
Press the button again to go to the
Select
Trend Lead Select
Pressure
Connector
and
Select Set
and , and
HI LO
.
moves you to the next
or LED will
HI LO
PG 2-5
CO
Select
AC
Print
Blood
connector
next limit, or press it several times until
none of the measurements flash and no
LEDs are lit. The instrument is now in
LO
its normal measurement mode. (If you do
not press any button for 10 seconds, the
instrument will automatically revert to its
normal measurement mode).
Note: If the language setting is configured to
Chinese and the alternate BP field to kPa, the
blood pressure will be displayed in kPa on the
screen, but the Systolic and Diastolic readings
on the right side of the monitor will be displayed
in mmHg. When setting the alarm limits, the
and alarm limits will be displayed in mmHg
LO
on the right side of the monitor and in kPa on the
screen.
7
Off
/ RESP
2
ALARMS
Off
Set
Select
Set
or
HI
HI