Welch Allyn Atlas Operator's Manual page 95

Reduce the frequency of blood pressure measurements or printouts if practical.
Charge Atlas for 24 hours and time battery life in use as specified above; if less than the specified battery
life is provided, the battery must be replaced.
E.1.7 Printer
PROBLEM:
Printer does not print
RECOMMENDED ACTIONS:
If paper is not feeding out of printer:
Check that paper is installed with end of paper extending beyond door slot.
Check that printer door is closed.
Check for paper scraps jamming in roller and gears in printer door.
Have unit repaired.
If paper is feeding out of printer, but it is blank:
Check that thermal side of paper faces the front of the Atlas Monitor.
Replace paper with a new roll (preferably with a known good partial roll).
Check that the printer door is fully closed and latched.
Have unit repaired.
PROBLEM:
Printing too light / too dark.
RECOMMENDED ACTIONS:
Replace paper with a new roll.
Have unit repaired.
PROBLEM:
Printing blurred.
RECOMMENDED ACTIONS:
Check that printer door is properly closed.
Replace paper with a new roll.
Have unit repaired.
PROBLEM:
Printer keeps printing without stopping (or without stopping for long).
RECOMMENDED ACTIONS:
If Print On Alarm is configured and a physiological value is near the alarm limit, multiple Print On Alarm
prints could be triggered in a row as the physiological value moves over the limit and then back into the
normal range again and again. This appears like continuous printing. Adjust the alarm limit so that the
current physiological value does not keep tripping the alarm, or change the Print On alarm setting to No
in the Advanced Configuration screen.
83