Disassembling The Stanchion - APRILIA SR 50 Workshop Manual

CYCLE PARTS
5.7.3.

DISASSEMBLING THE STANCHION

•
Remove the stanchion assembly, see (REMOVING
THE FORK LEG).
CAUTION Prepare a graduated receptacle with a capacity of
3 3
at least 300 cm (18.31 in
•
Let the fork leg enter the stanchion completely, turn the
stanchion assembly and let the fluid drain in the
container.
WARNING
Check the oil level. If lower than 103 cm
3
in ), top up or change.
•
Loosen and remove the screw (1) (bottom end) and
collect the copper washer (2).
•
Slide out the slider (3) with damper (4).
•
Turn the stanchion (5), collect the buffer (6) and the
counter spring (7).
•
Remove the dust seal (8).
•
Remove the circlip (9).
WARNING
While reassembling, fit the circlip (9) with the
sharp edge fully home (see figure).
•
Remove the seal (10).
5 - 30
.).
3
(6.28
SR 50