Advertisement
Quick Links
Advertisement
Related Manuals for Blue Seal E51
Summary of Contents for Blue Seal E51
- Page 1 E51 E50 E56 ELECTRIC RANGE AND COOK TOP...
- Page 2 P O Box 10-001 Christchurch New Zealand (03) 3891-007 Fax: (03) 3891-276 WORLD-WIDE BRANCHES UNITED KINGDOM Blue Seal Units 6-7, Mount Street Business Park Mount Street, Nechells Birmingham B7 5 QU (121) 327-5575 Fax: (121) 327-9711 UNITED STATES Moffat Inc...
-
Page 3: Table Of Contents
BLUE SEAL ELECTRIC HOBS & RANGES - E51 ELECTRIC BOILING TABLES - E50 ELECTRIC RANGES - E56 ELECTRIC CONVECTION RANGES CONTENTS PAGE SPECIFICATION INSTALLATION OPERATING INSTRUCTIONS CLEANING SERVICING INSTRUCTIONS PROBLEM SOLVING WIRING SCHEMATICS SPARE PARTS Date Purchased............. Serial No........… Dealer.......................... -
Page 5: Specification
SPECIFICATION RANGES INCLUDED IN THIS SPECIFICATION: E51-4D 4 radiant elements, Boiling table E51-4C 2 radiant elements plus 300mm griddle, Boiling Table E51-4B 600mm griddle, Boiling Table' E51-6D 6 radiant elements, Boiling table E51-6C 4 radiant elements plus 300mm griddle, Boiling Table... -
Page 6: Installation
Secure loosely with one bolt (supplied) each. E51 models only: Fit the leg tray. Align the holes in the corners of the tray with the threaded holes in the legs (approximately 150mm from floor) and secure with four ¼”... - Page 7 Connection to power supply must be carried out by a Registered Electrician. Undo the screw(s) at the top of the control panel and lower the panel downward. E51 Models - Bring the power supply cable through the channel under the base panel.
-
Page 8: Operating Instructions
OPERATING INSTRUCTIONS RADIANT HOTPLATES The controls for the radiant hotplates may be set at any position between high and low to provide the desire level of heating. An individual pilot light for each element will glow when the element cycles on and extinguish when the element cycles off. - Page 9 OPERATING INSTRUCTIONS CONVECTION OVEN (E56 SERIES) The oven is fitted with a fan, top and bottom elements. The thermostat maintains the oven temperature by controlling both element. Place oven racks in the desired position. 1. PREHEAT the oven by selecting the desired temperature. When the desired temperature is reached, the pilot light will go out.
-
Page 10: Cleaning
CLEANING CAUTION: ALWAYS TURN THE POWER SUPPLY OFF AT THE WALL SWITCH BEFORE CLEANING THIS UNIT IS NOT WATER PROOF. DO NOT USE WATER JET SPRAY TO CLEAN INTERIOR OR EXTERIOR OF THIS UNIT. RADIANT HOTPLATES Wipe the surface while still warm to remove spill-overs, grease etc. before they harden. -
Page 11: Servicing Instructions
SERVICING INSTRUCTIONS ENSURE POWER SUPPLY IS SWITCHED OFF BEFORE SERVICING. All servicing should be carried out by a competent electrical appliance serviceman with experience of commercial cooking equipment. CONTROL PANEL Undo the screw(s) at the top of the control panel and swing the panel down. FUSES are now accessible. - Page 12 SERVICING INSTRUCTIONS RADIANT AND SOLID ELEMENTS Tilt element sideways and remove spillage tray. Lift front of element, pull forward approximately 30mm and turn on edge. Remove terminal cover plate and disconnect wiring. Radiant Element 2.4kW at 240V = 10A 24 ohms Solid Elements 2.0kW at 240V = 8.3A 29 ohms ENERGY REGULATORS These should be checked for positive OFF and MAXIMUM positions and for...
-
Page 13: Problem Solving
PROBLEM SOLVING FAILURE OF INDIVIDUAL ITEMS, e.g one element Note: Switch off power supply or remove wall fuses for these tests. Check individual fuses located behind control panel. Check for an electrical short by checking there is NO continuity between any "phase in"... - Page 14 RESISTANCE TEST To check if an element is still functioning correctly, disconnect appliance from the mains supply, disconnect wires from the element and check the resistance (ohms) across the element when cold. Follow Steps 1, 2, 3 below to calculate the correct resistance (OHMS LAW).
-
Page 15: Continuity Test
CONTINUITY TEST To check if an Energy Regulator, Thermostat or Switch is functioning correctly, disconnect appliance from the mains supply, disconnect wires from the control and check for continuity. -11-... -
Page 16: Wiring Schematics
CIRCUIT SCHEMATICS -12-... - Page 17 CIRCUIT SCHEMATICS -13-...
- Page 18 CIRCUIT SCHEMATICS -14-...
- Page 19 CIRCUIT SCHEMATICS -15-...
-
Page 20: Spare Parts
SPARE PARTS BLUE SEAL E50/51/56 SERIES Part No Description 011654 Oven Top Element 1.75kW (E56) 010419 Oven Top Element 3kW (E50) 015710 Oven Bottom Element 4.5kW 010137 Radiant Surface Element 2.4kW 013600 Cast Surface Element 2.0kW 010422 Griddle Element 3.6kW...
Need help?
Do you have a question about the E51 and is the answer not in the manual?
Questions and answers