Subscribe to Our Youtube Channel
Related Manuals for Blue Seal Evolution G570
Summary of Contents for Blue Seal Evolution G570
- Page 1 I N S T A L L A T I O N A N D O P E R A T I O N M A N U A L GAS TARGET TOP / STATIC OVEN RANGE G570 For use in GB & IE 230096-8...
- Page 2 (tel): 800 263 1455 (Toll Free) NEW ZEALAND Moffat Limited Web: www.moffat.co.nz E.Mail: sales@moffat.co.nz Main Office: (tel): 0800 663328 UNITED KINGDOM Blue Seal Web: www.blue-seal.co.uk E.Mail: sales@blue-seal.co.uk Sales: (tel): +44 121 327 5575 (fax): +44 121 327 9711 Spares: (tel): +44 121 322 6640...
-
Page 3: Table Of Contents
Contents Blue Seal Gas Target Top Static Oven Range G570 Gas Target Top Static Oven Range. Introduction ....................2 Specifications .................... 3 Model Numbers Covered in this Specification General Gas Supply Requirements Gas Connection Dimensions ....................5 Installation ....................6... -
Page 4: Introduction
Introduction We are confident that you will be delighted with your BLUE SEAL Target Top Gas Static Oven Range, and it will become a most valued appliance in your commercial kitchen. To ensure you receive the utmost benefit from your new Blue Seal appliance, there are two important things you can do. -
Page 5: Specifications
Specifications Model Numbers Covered in this Specification G570 Gas Target Top Static Oven Range. General A commercial heavy duty, general purpose fully modular, gas fired Target Top Static Oven Range, having a high output, two stage double-ring iron cast burner offering accurate temperature control and infinitely variable heat with the heat radiating out from the centre of the Target Top. - Page 6 Specifications Gas Connection Gas supply connection point is located 130 mm from the right hand side, 32 mm from the rear and 655 mm from the floor and is reached from beneath the appliance. (Refer to the ‘Dimensions’ section). Connection is ¾" BSP male thread.
-
Page 7: Dimensions
Dimensions G570... -
Page 8: Installation
Blue Seal Target Top Static Oven Ranges are designed to provide years of satisfactory service and correct installation is essential to achieve the best performance, efficiency and trouble-free operation. -
Page 9: Location
Gas Connection NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON. Blue Seal Target Top Oven Ranges do not require an electrical connection, as they function totally on the gas supply only. It is essential that the gas supply is correct for the appliance to be installed and that adequate supply pressure and volume are available. -
Page 10: Commissioning
Installation NOTE: A Manual Isolation Valve must be fitted to the individual appliance supply line. Correctly locate the appliance into its final operating position and using a spirit level, adjust the legs so that the appliance is level and at the correct height. Connect the gas supply to the appliance. -
Page 11: Operation
Blue Seal appliances have been designed to provide simplicity of operation and 100% safety protection. Improper operation is therefore almost impossible, however bad operation practices can reduce the life of the appliance and produce a poor quality product. To use this appliance correctly please read the following sections carefully:- •... -
Page 12: Lighting The Pilot Burner - (Target Top)
Operation Lighting the Pilot Burner - (Target Top) Remove centre casting with the casting removal tool. Depress the control knob and rotate anti-clockwise to the ‘PILOT’ position. With the control knob depressed, manually light the pilot burner located in front of the main burner. Hold in the control knob for approximately 10 to 15 seconds, then release. -
Page 13: Lighting The Oven Pilot Burner
Operation Lighting the Oven Pilot Burner Pilot Burner viewing holes ! IMPORTANT DO NOT USE aluminium foil or trays directly on the cast iron sole plate(s). NEVER block or cover the openings on each side of the sole plate(s). This oven is fitted with a pilot as a standard option and flame failure protection, which is incorporated by way of a thermo-electric system for the main burner. -
Page 14: Oven 'Shut Down
Operation Control Knob in Oven ‘Shut-Down’ ’Off’ Position NOTE: DO NOT attempt to rotate the Thermostat Control Knob anti-clockwise back to the ‘O’ Off position as the Knob and Gas Valve will be damaged. partially depress To turn 'Off' the oven completely, thermostat control knob whilst turning clockwise to the 'O' Off position, the pilot burner will extinguish. -
Page 15: Cleaning And Maintenance
Cleaning and Maintenance AUTIO N Always turn 'Off' the gas supply before cleaning. This appliance is not water proof. Do not use water jet spray to clean interior or exterior of this appliance. General Clean the Target Top regularly. A clean appliance looks better, will last longer and will perform better. -
Page 16: Periodic Maintenance
Cleaning and Maintenance c. DO NOT use water on the castings while they are still hot as cracking may occur. Should it be necessary to clean the castings, allow the castings to cool and then remove for cleaning. Clean using a soft cloth moistened with a mild detergent and hot water solution and a scrubbing brush. -
Page 17: Fault Finding
Fault Finding This section provides an easy reference guide to the more common problems that may occur during the operation of your appliance. The fault finding guide in this section is intended to help you correct, or at least accurately diagnose problems with your appliance. Although this section covers the most common problems reported, you may encounter a problem not covered in this section. -
Page 18: Gas Conversion And Specifications
Gas Conversion and Specifications Conversion Procedure AUTIO N Ensure that the Unit is isolated from the gas supply before commencing servicing. NOTE: • These conversions should only be carried out by qualified persons. All connections must be checked for leaks before re-commissioning the appliance. •... - Page 19 Gas Conversion and Specifications Target Top - Pilot Burner Main Burner Pilot Burner To remove the pilot burner, disconnect the gas Injectors supply tube from the base of the pilot burner. Remove the bolt securing the retaining plate holding the pilot burner and thermo couple to the mounting bracket.
-
Page 20: Gas Specifications
Gas Conversion and Specifications Oven Injector: With the gas supply turned off at the main supply, Shown with door removed for ease of viewing unscrew and remove the 6 screws securing the lower lintel to the front of the oven. Open the oven door and remove the vitreous enamelled tray from inside the oven. -
Page 21: Gas Regulator
Gas Conversion and Specifications Gas Regulator NOTE: The regulator supplied is convertible between Natural Gas and LPG, but it’s outlet pressure is fixed ex-factory and is NOT to be adjusted. NOTE, Pin rotated for Natural Gas NOTE, Pin rotated for LPG Fig 21 Ensure that the gas supply is turned ‘OFF’... -
Page 22: Gas Specifications
Gas Conversion and Specifications Gas Specifications - Non CE Only (Australia / New Zealand): Nat. Gas LP Gas (Propane) Main Burner Injector (Inner Ring) Ø 1.70 mm Ø 1.10 mm Main Burner Injector (Outer Ring) Ø 2.60 mm Ø 1.55 mm Pilot Burner Injector 0.35 0.25... -
Page 23: Replacement Parts List
Replacement Parts List Replacement Parts List IMPORTANT: Only genuine authorized replacement parts should be used for the servicing and repair of this appliance. The instructions supplied with the parts should be followed when replacing components. For further information and servicing instructions, contact your nearest authorized service branch (contact details are as shown on the reverse of the front cover of this manual). - Page 24 Oven Side Rack RH. 227896 Oven Rack. 227850 Adjustable Leg (150 mm) 229674 Rear Roller Assy. Gas Conversion Kits Gas Type to Convert to: Model Nat. Gas (G20) LPG (Propane) (G31) G570 231976 231975 Accessories 228800 Ranges 900 mm Plinth Kit.
Need help?
Do you have a question about the Evolution G570 and is the answer not in the manual?
Questions and answers