Telephone Base And Charger Installation; Telephone Base Installation; Charger Installation - AT&T CRL81112 Complete User's Manual

Getting started

Telephone base and charger installation

Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 8 for details.

Telephone base installation

•
Plug the large end of the
telephone base power
adapter into a power
outlet not controlled by
a wall switch.
•
Route the power
adapter cord and the
telephone line cord
through these slots.
•
Raise the antenna.

Charger installation

•
Plug the small end of the telephone base power adapter into
the power adapter jack on the back of the telephone base.
Plug the power adapter into a power
outlet not controlled by a wall switch.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To
order a replacement power adapter, visit our website at
www.telephones.att.com
1 (800) 222-3111
2. The power adapters are intended to be correctly oriented in
a vertical or floor mount position. The prongs are not designed
to hold the plug in place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
Telephone
line cord
or call
. In Canada, dial
5
•
Plug one end of the
telephone line cord
into a telephone jack
or a DSL filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
The DSL filter must be
plugged into the telephone
wall jack.
•
Plug the other end
of the telephone line
cord into the telephone
jack on the back of the
telephone base.
1 (866) 288-4268
.