IBM 4247 Maintenance Information page 99

Table 14. MAP 0180: Top Cover Interlock (continued)
Step Questions/Actions
Inspect the following parts for wear, damage, or binds:
2.
v Top cover
v Top cover magnet (Located near the right end of the
stacker assembly when the cover is closed)
Note: When the ASF/Stacker top cover is installed,
there must not be a magnet in the cover near the
operator panel.
Ensure the ASF stacker assembly is installed correctly.
Both sides must be positively latched and the cable
must be positively clicked in place.
Are the parts OK?
Yes
Install a new ASF stacker
assembly. – or –
Install a new logic board For
Model A00, see "Logic Board -
Model A00" on page 370. For
Models 001 and 002, see "Logic
Board - Models 001 and 002" on
page 378. Or "Logic Board -
Model 003" on page 366.
Run T&D in automatic mode to
verify correct printer operation.
For Model A00, see "How To
Run the Test and Diagnostic
(T&D) Programs" on page 161.
For Models 001, 002, or 003, ,
see "How To Run the Test and
Diagnostic (T&D) Programs" on
page 201.
No
Repair as needed.
Run T&D in automatic mode to
verify correct printer operation.
For Model A00, see "How To
Run the Test and Diagnostic
(T&D) Programs" on page 161.
For Models 001, 002, or 003,
see "How To Run the Test and
Diagnostic (T&D) Programs" on
page 201.
Chapter 1. Diagnosing Problems
99