IBM 4247 Maintenance Information page 556

8. Power-on the printer. After the first normal initialization, an information message might appear:
070 PRINTER BOARD CHANGED
VERIFY CONFIGURATION SETTINGS
Press the printer Stop key to silence the beeper and go to the Not Ready state.
This message means that a Printer Configuration parameter value has changed when the code was installed.
Print the 4247 Custom Set information using the Test key and Print Custom Sets utility. Mark this printout as
'After'. Compare the Before and After printouts and re-install the correct parameter values in each affected
Custom Set using the Menu key.
9. If more than one Custom Set was being used by the customer, you should recall the last used Custom Set by
using the Menu key and Configuration Storage with the Enter key. When the Recalled message is
displayed, press the Start key to go to a Ready state. The Custom Set that has been recalled and is being
used by the printer is shown as <X> in the upper right corner of the display. The parameter values in <X> can
be printed using the Test key and the Printer Configuration utility.
Appendix C. Flashing the Memory of the Model 003
556