IBM 4247 Maintenance Information page 372

Notes:
a. To remove printhead cables, hold the cable just above the connector and pull the cable out of the
connector. These are not locking connectors.
b. Some connectors have retaining clips.
c. The sensor connector can be disconnected after the logic board is partially removed.
d. Use Figure 114 and Figure 115 on page 373 as reference for the connector locations and cable
paths to aid installation.
e. Each connector is unique in size and shape.
Operator
Tractors
Panel
Stacker
Carriage
Print Head and Ribbon
Motor
Motor
Ribbon Lift Motor
Figure 114. Model A00 Early-Level Logic Board Connector Locations
Sensors
Power
Supply
Paper
Feed
Motor
AFTA
Chapter 5. Removals and Adjustments
372