IBM 4247 Maintenance Information page 166

Online
Auto Sheet Feed
Manual Sheet Feed
Front Push
Path
Quiet Micro
6 5
4
Rear Pull
Rear Push
Tear Park Font
12 11 10
Figure 12. Operator Panel Key Press Sequence
If a key is not pressed in approximately 10 seconds, an error message will display. If a timeout error message
occurs, press the Micro
6. Continue to press the keys as each request is displayed.
7. If an error message is displayed, go to "T&D Error Messages and Actions" on page 190.
8. The test completed successfully if the display advances to the next test number.
T&D06 - Parallel Attachment Test
Note: The parallel loop-back connector needs to be installed for this test.
If the loop-back connector is not installed, an error message will be displayed. To bypass this message, press the
Micro key twice to advance to the next test.
Display:
If an error message is displayed, go to "T&D Error Messages and Actions" on page 190. The test completed
successfully if the display advances to the next test number.
T&D07 - Not Used
Press the Micro key to bypass this message.
Load/
Form
Micro Feed Online
2 1
3
Line Menu/
Pitch Feed Enter
9 7
8
key twice to repeat T&D05
T&D 06 USER
166
Chapter 2. Diagnostics