IBM 4247 Maintenance Information page 144

Table 18. Error Messages for Models 001, 002, and 003 (continued)
Message
201 NO ATTACHMENT CARD FOUND
MODEL 003 TWINAX CODE
SEE USER'S GUIDE
202 NEW ATTACHMENT CARD FOUND
DIAGNOSTIC IN PROGRESS
PLEASE WAIT (flashing)
MODEL 003
SEE USER'S GUIDE
203 ATTACHMENT CARD FAILURE
MODEL 003
SEE USER'S GUIDE
Description
A serial, LAN, or twinax attachment card
was not found during the current power on,
but was previously.
A new type of attachment card was found
during the current power on. This will occur
on the first power-on following the
installation of a new card.
An error occurred during attachment card
flash memory power on initialization. The
problem may be from the base code, the
attachment card, the attachment card
interposer connector, or the logic board.
See "T&D30 - Adapter Board Link Test" on
page 227.
Action
1. If attachment card was removed,
confirm this by pressing the start key.
2. Otherwise, power off the printer and
reseat the attachment card.
Press Start to confirm installing a new
attachment card and to continue power on
initialization. After the code transfer is
complete, Coax or Twinax will be displayed
on the operator's panel.
1. Reflash the basecode. See
"Appendix C. Flashing the Memory of
the Model 003" on page 549.
2. If error reoccurs, replace the
attachment card. See "Model 003
Attachment Cards: Serial, Twinax, LAN,
Coax" on page 359.
a. If you are having difficulty physically
installing the attachment card,
inspect the attachment card guide
assembly and the interposer
connector for damage. Replace if
necessary. See "Attachment Card
Guide Assembly with the Interposer
Connector (Model 003)" on
page 364.
3. If error reoccurs, replace logic board,
see "Logic Board - Model 003" on
page 366.
Chapter 1. Diagnosing Problems
144