Electrolux Automower G2 Operator's Manual page 18

Installation
• If the working area borders against a small ditch, for
example, a flower bed or a small elevation, e.g. a
low verge (3-5 cm), the boundary wire should be
laid 30 cm inside the working area. This prevents
the wheels from driving into the ditch or up onto the
verge.
• If the working area borders against a flat path or the
like that lies level with the lawn, it is possible to
allow the Automower™ to run a little over the path.
The boundary wire should then be laid 10 cm from
the edge of the path.
Remember the following with regard to the working
area boundaries:
• Automower™ can mow areas with a slope of up to
33 cm per metre inside the working area. Areas that
slope more must be demarcated by the boundary
wire. If any part of the working area's outer edge
has a gradient of 1:5 (20 cm/m) or more, the wire
should be laid inside where the slope starts. The
Automower™ may find it difficult to turn at the loop
where the ground slopes steeply.
• Use the boundary wire to demarcate areas inside
the working area, for example, flower beds and
fountains. Lay the wire up to the area, around it and
then return along the same route. If staples are
used, the wire should be laid under the same staple
on the return route.
• Obstacles that can withstand a collision, for
example, trees or bushes higher than 15 cm, do not
need to be demarcated by the boundary wire. The
Automower™ will turn when it collides with this type
of obstacle.
However, for the most gentle and silent operation,
it is preferable to demarcate all fixed objects in and
around the working area.
18 electrolux automower
Minimize
3012-381
3012-383
3012-108