Electrolux Automower G2 Operator's Manual page 16

Installation
Do not put the charging station in a corner or pocket in
the working area.
If the garden consists of two large lawns joined by a
passage, it may be difficult for the Automower™ to find
the entrance to the passage. Making it difficult to work
efficiently in both areas. One way to make the mower
effectively reach both areas is to position the charging
station in the middle of the passage.
When the charging station needs to be placed in a
passage, it is appropriate to manually set the exit
direction, see "Charge exit settings (3-1)" on page 31.
This will ensure both areas are mown equally and the
grass close to the charging station will not appear
downtrodden.
Boundary wire
For a successful installation the placement of the
boundary wire should be planned carefully. Planning is
simplified if you make a sketch of the working area,
including all obstacles. Draw how the boundary wire
should be routed on the sketch.
The boundary wire should be laid so it:
• Forms a loop around the working area for the
Automower™. Only original boundary wire ought to
be used. This is tinned and has a high quality
insulation to withstand the dampness in the ground.
• Is a maximum of 500 metres long.
• Maintains a maximum distance of 35 metres from
Automower™ in the entire working area.
• Does not lie on a sharp incline. The Automower™
may find it difficult to reverse back, especially in
damp weather conditions when there is a large risk
of skidding.
16 electrolux automower
3012-235
3012-237