Full Speed Usb - Honeywell 7120 Orbit User Manual

I
NSTALLATION

Full Speed USB

1. Turn off the host device.
2. Plug the male 10-pin RJ45 end of
the USB cable into the 10-pin
socket on the 7120.
3. Plug the other end of the USB
interface cable into the host
device's USB port.
4. Turn on the host device.
When the scanner first receives
power, the blue and white LED
will toggle on and off then the
scanner will beep once.
As a default, the MS7120-38 leaves the factory with USB Keyboard
Emulation Mode enabled. Scan the following bar code to configure
the MS7120-38 for USB Serial Emulation Mode.
Plugging the scanner into the USB port of the PC does not guarantee
that scanned information will appear at the PC. A software driver and
the correct configuration settings are also required for proper
communication to occur.
For Previous User's of the MX009
In order for the new integrated USB Orbit* to function with the same
serial emulation driver as the old external USB Orbit, scan the
following bar code.
* Rev L Orbits or above.
³ 3 1 6 4 6
³ 3 1 6 4 7
Figure 13.
0
0
11