Low Speed Usb (-38); Full Speed (-40) - Honeywell Eclipse MS5100 Series Installation And User Manual

I
NSTALLATION
USB

Low Speed USB (-38)

:
Full Speed USB (-40)
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector of the USB cable into the
jack on the Eclipse. There will be a
'click' when the connection is made.
3. Connect the other end of the USB
cable to the host USB port.
4. Turn on the host system.
As a default, the MS5145-38 leaves the factory with USB Keyboard
Emulation Mode enabled.
For information on configuring the MS5145-38 for USB Serial Emulation
Mode, please refer to the USB section of the MetroSelect Single-Line
Configuration Guide (00-02544X).
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. All Eclipse's are shipped already configured with a set of
factory defaults. Please refer to the MetroSelect Single-Line
Configuration Guide or MetroSet2's help files for instructions on
changing the scanner's factory default configuration. The scanner and
host system must use the same communication protocols.
See page 5.
Figure 10. USB
11