Error Symptoms - IBM xSeries 300 Hardware Maintenance Manual

Error Code/Symptom
217-XXX-001
(Failed BIOS Fixed Disk test)
Note: If RAID is configured,
the fixed disk number refers
to the RAID logical array.
217-XXX-002
(Failed BIOS Fixed Disk test)
Note: If RAID is configured,
the fixed disk number refers
to the RAID logical array.
264-XXX-0NN
(NN = SCSI ID of failing
Tape Drive)
264-XXX-999
(Errors on multiple tape
drives, see error text for more
info)
301-XXX-000
(Failed Keyboard test)
405-XXX-000
(Failed Ethernet test on
controller on the System
Board)
405-XXX-00N
(Failed Ethernet test on
adapter in PCI slot N)
415-XXX-000
(Failed Modem test)

Error symptoms

General
CD is not working properly. 1. Clean the CD.
CD-ROM drive tray is not
working.
(The server must be
powered-on.)
66
Hardware Maintenance Manual: xSeries 300
FRU/Action
1. Fixed Disk 2
1. Fixed Disk 3
1. Tape Cartridge, if user executed the Read/Write Tape Drive test (XXX = 256)
2. SCSI or power cable connected to the tape drive with SCSI ID NN
3. Tape drive with SCSI ID NN – refer to Help and Service Information appendix of
tape drive's User Guide.
4. I/O Legacy Board or SCSI Controller – run SCSI Controller diagnostic to
determine of SCSI bus is functioning properly.
1. See error messages/text in the PC Doctor error log for detailed information on
each individual tape drive error.
1. Keyboard
1. Verify that Ethernet is not disabled in BIOS.
2. System Board
1. Adapter in PCI slot N.
2. System Board
1. Cable
2. Modem
3. System Board
FRU/Action
2. Run CD-ROM diagnostics.
3. CD-ROM Drive
1. Insert the end of a paper clip into the manual tray-release opening.
2. Run CD-ROM diagnostics.
3. CD-ROM Drive