Installation - Fujitsu ASU24CL Installation Manual

WIRED REMOTE CONTROL UNIT
INSTALLATION MANUAL
(PART NO. 9315757012)
BEFORE INSTALL WIRED REMOTE CONTROL UNIT
• The wired remote control unit is an option. It isn't included in main body of air-conditioner.
•
When you use wired remote control unit, some functions may not be used.
•
Please use the recommended wired remote control unit.
(Before installing, Please read the FEATURES AND FUNCTIONS section of OPERATING MANUAL to confirm the
concerned contents.)
(1) Before installing, be sure to disconnect all power supply.
(2) Don't touch the heat exchanger.
(3) During installing or removing operation, be sure not to have wire catched by parts or draw it hard. Or it
may result troubles to the air-conditioner.
(4) Avoid place in direct sunlight.
(5) Select place that will not be affected by the heat from a stove, etc.
(6) Insure the length of wire is not over the recommended maximum length.
(7) Before setting up the wired remote control unit, please confirm whether air-conditioner can receive the
signal.
1. FRONT PANEL, CONTROL BOX COVER AND DISPLAY CASE REMOVAL
(1) Refer to "FRONT PANEL REMOVAL AND INSTALLATION" to remove the front panel.
(2) Remove screws then remove the control box cover.
(3) Remove the display case and connector.
2. CONNECTING TO CONTROL UNIT OF WIRE
(1) Pass the connector from the hole in the back.
(2) Connect the wire of wired remote control unit to the board of Control unit.
(3) Hook the wire to the rib.
(4) Use wire clamper and screw to fasten the wire.
connect the
wire
3. FRONT PANEL, CONTROL BOX COVER AND DISPLAY CASE

INSTALLATION

Install front panel, control box cover and display case by the reverse proce-
dures as stated in "1.FRONT PANEL, CONTROL BOX COVER AND DISPLAY
CASE REMOVAL " ..
control box
cover
screw
rib
CAUTION
hole
conduit holder
ENGLISH
connector
display case
wire clamper
screw
screw
wire clamper
original wire of
control unit
wire of
wired
remote
control
unit