Advertisement
ADJUSTMENTS
1. Check the backlash between the chute drive gear and
driven gear. Adjust as necessary.
BACKLASH: 0.5 ~ 1.0 mm (0.02 ~ 0.04 in)
2. Check that the chute rotates smoothly when the chute
handle is operated.
If the chute handle does not rotate smoothly, loosen chute
handle bracket B bolt and chute handle bracket A nut and
slightly shift the position of the chute handle brackets until
the chute handle operates smoothly. Retighten the
hardware after adjustment.
3. Readjust the chute drive gear backlash if necessary.
4. Check that the chute guide is in the most raised position
when the chute guide lever is in the "UP" position.
5. Adjust the chute guide control cable by loosening the lock
nut and turning the adjusting nut (chute guide lever side)
right or left.
6. After adjustment, tighten the lock nut.
PRE-DELIVERY INSPECTION CHECKLIST
Refer to the owner's manual or shop manual for more
detailed procedures if necessary.
1. The snowblower is shipped WITHOUT ENGINE
OIL.
Remove the oil filler cap/dipstick and add oil to bring
the level to the upper limit.
Do not overfill. If the engine is overfilled, the excess
oil may get transferred out the crankcase breather
hose.
Use SAE 5W-30 engine oil with an API rating of SJ
or later.
HS928K1 • HS1332 SNOWBLOWERS
CHUTE
DRIVE
GEAR
LOCK
NUT
UPPER LIMIT
DRIVEN
GEAR
0.5 ~ 1.0 mm (0.02 ~ 0.04 in)
CHUTE
GUIDE
LEVER
CHUTE GUIDE
ADJUSTING
NUT
UPPER LIMIT
LOWER LIMIT
OIL FILLER CAP/
DIPSTICK
9 of 13
Advertisement
