Advertisement
7. Check the scraper bar and skid shoe adjustments:
The skid shoes can be mounted on the front of the auger housing (front mount) or on the rear of the auger
housing (rear mount). The rear-mount skid shoe adjustment is shown. The front-mount skid shoe
adjustment procedure is the same.
a. Place the snowblower on a level surface.
On track-type snowblowers, step on the foot pedal and
set the auger in the middle position.
b. Loosen the four 8 x 16 mm bolts washers supporting the
skid shoes. Raise the skid shoes so that the scraper bar
is resting on the surface.
c. Measure the auger-to-scraper bar clearance. If needed,
adjust by loosening the five 6 mm flange nuts and the
two 8 x 16 mm bolt-washers. Evenly set the scraper bar
to obtain the specified clearance.
AUGER-TO-SCRAPER BAR CLEARANCE
2.0 ~ 4.0 mm (3/32 ~ 5/32 in)
d. After adjustment, tighten the five 6 mm flange nuts and
the two 8 x 16 mm bolt-washers.
e. Set the scraper bar ground clearance so it will clear the
type of surface the snowblower is expected to operate
on.
SCRAPER BAR GROUND CLEARANCE
Ordinary surfaces
Smooth icy surfaces
Rough surfaces
f.
Set the skid shoes evenly on the surface.
g. After adjustment, tighten the four 8 x 16 mm bolt-
washers.
REAR-MOUNT SKID SHOES (2
4.0 ~ 8.0 mm (5/32 ~ 5/16 in)
2.0 ~ 5.0 mm (3/32 ~ 3/16 in)
25.0 ~ 30.0 mm (1 ~ 1-13/16 in)
HS928K1 • HS1332 SNOWBLOWERS
FRONT-MOUNT SKID SHOES (2
AUGER-TO-SCRAPER BAR CLEARANCE
8 x 16 mm
BOLT-WASHER (2)
SCRAPER BAR GROUND CLEARANCE
8 x 16 mm
BOLT-WASHER (4)
AUGER
SCRAPER BAR
REAR SKID
SHOE (2)
8 x 16 mm
BOLT-WASHER (4)
6 mm
FLANGE NUT (5)
SCRAPER BAR
REAR SKID
SHOE (2)
11 of 13
Advertisement
