Honda HS928K1 Instructions Manual page 7

• Wheel-Type
1. Install the lower handle cap.
2. Set the handle and install the four handle holder bolts.
• Route the choke cable outside the handle.
• Route the other cables and code inside the handle.
3. Install the four joint washers and tighten the four nuts.
TORQUE: 22 N•m (16 ft-lb)
WIRE BAND INSTALLATION
Secure the following with the wire bands as shown.
Left side
• Handle
• Throttle cable
• Choke cable
Right side
• Engine stop switch wire
• Drive clutch cable
• Auger clutch cable
• Chute guide control cable
HS928K1 • HS1332 SNOWBLOWERS
JOINT WASHER (4)
HANDLE
HANDLE
HOLDER
BOLT (4)
LEFT SIDE
HANDLE
WIRE BAND
THROTTLE
CABLE
RIGHT SIDE
DRIVE
CLUTCH
CABLE
CHUTE GUIDE
CONTROL CABLE
NUT (4)
CAP (2)
CHOKE
CABLE
ENGINE
AUGER
STOP
WIRE
CLUTCH
SWITCH
BAND
CABLE
WIRE
7 of 13