Advertisement
HS928K1 • HS1332 SNOWBLOWERS
DAMAGE OR MISSING PARTS
• For parts lost or damaged in transit, refer to section 3 of the Warranty Policy and Procedures Manual.
• For parts left out by the factory, refer to section 6 of the Warranty Policy and Procedures Manual.
UNCRATING
1. Remove and discard the crate top frame, side, and braces.
2. Remove and discard the shipping braces from the engine bed side plates and handlebar assembly.
3. After assembly is completed, push the snowblower off the crate base.
You can drive the snowblower off the crate base after adding oil (page 9) and fuel (page 10).
a. All track-driven models:
Bend the crate's forward track stops flat against the crate base. Step
on the height adjustment pedal, and push down on the handlebar to
raise the auger housing to the highest position.
b. Move the transmission release lever to the RELEASED position for
manual pushing or to the ENGAGED position for self-propelled use.
c. Move the snowblower forward, off the crate base. Keep downward
pressure on the handlebars to avoid catching the scraper bar on the
crate base.
ASSEMBLY
WHEEL INSTALLATION (WHEEL TYPE ONLY)
1. Set the wheel onto the wheel shaft and insert the shaft pin.
2. Insert the split pin in the wheel shaft and spread ends as
shown.
HANDLE INSTALLATION
• Track-Type
1. Install the lower handle caps.
2. Set the handle and install the four joint washers and four
bolts.
• Route the choke cable outside the handle.
• Route the other cables and engine stop switch harness
inside the handle.
3. Install and tighten the four nuts (5).
TORQUE: 22 N•m (16 ft-lb)
6 of 13
HEIGHT
ADJUSTMENT
PEDAL
RELEASE
LEVER
WHEEL ASSEMBLY (2)
SHAFT PIN (2)
SHAFT PIN
SPLIT PIN (2)
NUT (4)
HANDLE
BOLT (4)
JOINT WASHER (4)
CAP (2)
Advertisement
