Advertisement
HS928K1 • HS1332 SNOWBLOWERS
CHUTE INSTALLATION
1. Install the chute.
2. Install the three 8 x 15 mm special bolts and
tighten the three 8 mm lock nuts.
3. Connect the chute guide control cable and check
the adjustment (see page 9).
CHUTE HANDLE INSTALLATION
1. Apply grease to the chute drive gear.
2. Loosely install the chute drive gear
with the 8 mm flat washer and 8 mm
flange nut.
3. Remove the right upper side handle
nut, joint washer, and handle holder
bolt.
4. Route the following cables and wire
harness around chute handle bracket
B properly as shown:
• Chute guide control cable
• Auger clutch cable
• Drive clutch cable
• Work light wire harness
5. Loosely install chute handle bracket
B with the collar (HS1332 only) and
6 x 12 mm flange bolt (HS928K1) or
6 x 16 mm flange bolt (HS1332)
6. Loosely install chute handle bracket
A with the handle holder bolt, joint
washer, and 8 mm flange nut.
7. Tighten the 8 mm flange nut securing
chute handle bracket A.
8. Tighten the 6 mm flange bolt securing
chute handle bracket B.
9. Tighten the chute drive gear 8 mm
flange nut securing the chute drive
gear.
10.After installation, check that the
cables and work light wire harness
are not touching the chute handle.
8 of 13
CHUTE CONTROL
GUIDE CABLE
CHUTE HANDLE BRACKET A
TRACK TYPE
HANDLE
HOLDER
BOLT
JOINT
WASHER
HANDLE
HOLDER
BOLT
6 x 12 mm FLANGE
BOLT (HS928K1)
6 x 16 mm FLANGE
BOLT (HS1132)
COLLAR (HS1336 ONLY)
CHUTE HANDLE
BRACKET B
HS928K1
CHUTE
HANDLE
BRACKET B
CHUTE
GUIDE
CONTROL
CABLE
CHUTE
WHEEL TYPE
UP
CHUTE
HANDLE
BRACKET A
8 mm
FLANGE
CHUTE
NUT
HANDLE
CHUTE DRIVE GEAR
HS1332
CHUTE
HANDLE
WORK LIGHT WIRE
BRACKET B
HARNESS
AUGER
CLUTCH
CABLE
DRIVE
CLUTCH
CABLE
8 mm LOCK
NUTS (3)
8 x 15 mm
SPECIAL BOLT (3)
UP
HANDLE
HOLDER
BOLT
CHUTE HANDLE
BRACKET B
8 mm FLAT
WASHER
8 mm
FLANGE NUT
CHUTE
GUIDE
CONTROL
CABLE
Advertisement
