Advertisement
HS928K1 • HS1332 SNOWBLOWERS
2. Check the hydrostatic transmission fluid level while the
engine is cold.
If necessary, fill the transmission reservoir to the
temperature compensated level shown in the following table
by removing the reservoir cap and cup.
Use only Honda Hydrostatic Fluid. P/N 08208-HST01
3. Install the reservoir cap and cup. Do not over-tighten the
cap.
4. Remove the upper level bolt from the auger transmission
and add oil until oil runs out the bolt hole. Install the upper
level bolt.
Use SAE 90 gear oil.
Part number: 08739-90W
5. Drain the fuel tank and the carburetor float bowl. Fill the fuel
tank with fresh, unleaded 86 pump octane or higher gasoline.
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling
fuel.
• Stop engine and keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
Refer to the owner's manual for facts about oxygenated fuels.
6. Wheel-types: Check tire air pressures and inflate to 8.0 psi
(55 kpa) if necessary.
NOTICE
Over-inflating the tires may damage the tires and may cause the
snowblower to pull to one side. Do not over-inflate the tires.
10 of 13
WARNING
RESERVOIR
CAP
RESERVOIR
CUP
TRANSMISSION
RESERVOIR
UPPER
OIL LEVEL (20∞)
LOWER
UPPER LEVEL BOLT
DRAIN KNOB
UPPER
LIMIT
LOWER
LIMIT
Advertisement
