Migrating The E-Series Server From An Isr G2 Into A Cisco Isr 4451-X - Cisco UCS E-Series Installation Manual

Migrating the E-Series Server from an ISR G2 into a Cisco ISR 4451-X

•
Migrating the E-Series Server from an ISR G2 into a
Cisco ISR 4451-X
If you are migrating the E-Series Server from an ISR G2 into a Cisco ISR 4451-X, you must first update
the CIMC firmware image to release 2.0(1.20130626092411) or the latest version and the BIOS
firmware image to release 1.5.0.2 or the latest version—while the E-Series Server is still installed in the
ISR G2—and then migrate it into the Cisco ISR 4451-X.
We strongly recommend that you upgrade both the CIMC and the BIOS firmware images.
For CIMC firmware installation instructions, see the "CIMC Firmware Management" chapter in the GUI
Configuration Guide for Cisco UCS E-Series Server Modules Integrated Management Controller on
Cisco.com.
If you migrate the E-Series Server into the Cisco ISR 4451-X without first updating the CIMC firmware,
the E-Series Server will continuously reset. To stop the reset and install the firmware, see the
the E-Series Server from Resetting and Updating the CIMC Firmware" section on page
Stopping the E-Series Server from Resetting and Updating the CIMC Firmware
If you migrate the E-Series Server into the Cisco ISR 4451-X without first updating the CIMC firmware,
the E-Series Server will continuously reset. Use this procedure to stop the reset and install the firmware.
Some of the steps in this procedure are performed from the router, and other steps are performed from
Note
the E-Series Server.
DETAILED STEPS
Command or Action
Step 1
Router# hw-module subslot slot/subslot
maintenance enable
Step 2
Router# hw-module subslot slot/subslot session imc
Hardware Installation Guide for Cisco UCS E-Series Servers
28
0 12090323 12.2(20120829:165313)
1 12090323 12.2(20120829:165313)
2 12090323 12.2(20120829:165313)
R0 12090323 12.2(20120829:165313)
F0 12090323 12.2(20120829:165313)
To verify that the router recognizes the E-Series Server, use the show hw-module subslot all oir
command:
Router# show hw-module subslot all oir
Module Model Operational Status
------------- -------------------- ------------------------
subslot 0/0 ISR4451-X-4X1GE ok
subslot 1/0 UCS-E140S-M1/K9 ok
subslot 2/0 UCS-E140S-M1/K9 ok
Purpose
Disables error recovery, which stops the E-Series Server
from being reset.
Note Enter the commands in Step 1 and Step 2 from the
router.
Starts a CIMC session.
"Stopping
28.
OL-26447-03