Cisco UCS E-Series Installation Manual page 33

The hard disk drives must be installed in the following order:
Note
HDD0
1.
HDD1
2.
HDD2
3.
Procedure
Use this procedure to install or replace a hard disk drive on the E-Series Servers.
Connect the wrist strap clip to an unpainted portion of the chassis frame to channel unwanted ESD
Step 1
voltages to ground.
Turn off power to the router.
Step 2
Note
Using either a number 1 Phillips screwdriver or a small flat-blade screwdriver, unscrew the captive
Step 3
screws on the faceplate and remove the cover faceplate. See the following figures.
Figure 13
1 Captive screws
OL-26447-03
Alternatively, the Cisco 3900 ISR G2 and the Cisco ISR 4451-X support OIR. See the
Insertion and Removal" section on page
Replacing a Hard Disk Drive on the Single-Wide E-Series Server
Installing or Replacing Hard Disk Drives on the E-Series Servers
29.
2
1
2 Hard disk drive assembly
Hardware Installation Guide for Cisco UCS E-Series Servers
"Online
33