Installing The E-Series Server Into The Router - Cisco UCS E-Series Installation Manual

Removing Slot Dividers
To install double-wide E-Series Server in router slots, you must remove the slot dividers. Use this
procedure to remove the slot dividers from the module slot.
Procedure
Remove any installed service modules, blank faceplates, and slot adapters from the router slot that you
Step 1
plan to use.
Loosen the retention screw on the front of the slot divider.
Step 2
Pull the slot divider straight out of the module slot.
Step 3
What to Do Next
Install the E-Series Server into the router. See the
on page

Installing the E-Series Server into the Router

Before You Begin
Verify that you have done the following:
1.
2.
3.
For the Cisco 3900 ISR G2—If you are using PoE, and you want to install one double-wide E-Series
Note
Server and any number of server modules in a Cisco 3900 ISR G2, you must use a second AC and PoE
supply to support this configuration.
For example, if you have a Cisco 3900 ISR G2 that has a PoE-capable switch providing power to phones,
and you want to install a double-wide E-Series Server in one slot and one or two single-wide servers in
the other slots, then you must use a second AC and PoE supply to support this configuration.
E-Series Servers can be installed either before or after mounting the router, whichever is more
convenient. Use this procedure to install an E-Series Server into a router.
OL-26447-03
25.
Removed the blank faceplates installed over the slot that you intend to use. See the
Installing Blank Faceplates" section on page
Saved the blank faceplates for future use.
Prepared the slot for the module form factor that you are installing. See the
Slot for E-Series Server Installation" section on page
"Installing the E-Series Server into the Router" section
21.
22.
Hardware Installation Guide for Cisco UCS E-Series Servers
Installing the E-Series Servers
"Removing and
"Preparing the Router
25