Setting Up The Digital Scanner; Installing The Interface Cable - Motorola DS3508 Manual

Setting Up the Digital Scanner

Installing the Interface Cable

NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
Connectors vary from those illustrated, but the steps to connect the digital scanner are the same.
Loosen the two screws on the cable clamp at the bottom of the scanner and gently pull the clamp away from
1.
the bottom of the scanner.
Removing the Cable Clamp
Figure 1-2
Open the clamp and plug the interface cable modular connector into the cable interface port on the bottom of
2.
the scanner handle.
Inserting the Interface Cable
Figure 1-3
Gently tug the cable to ensure the connector is properly secured.
3.
Getting Started 1 - 3