Communications - JVC SW-D7000U Instruction Manual

SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
DEFAULT:
Format to decode SW-D7000U Plus recorded tapes. This is the factory default setting.
INDICATORS:
Decoding of videotapes recorded on alternative multiplexers will have indicators as follows:
" SW-D7000U – "JVC"
"
Calibur – "CBR"
"
Calibur Lite – "DM/Mini"
" Dedicated Micros – "DM/Mini"
" Robot – "ROBOT"
These indicators will appear only if the programmer has selected the corresponding menu option
under VCR SETUP sub menu PLAYBACK FORMAT to decode tapes that were recorded on
alternative multiplexers. The menu appears as follows:
If tapes cannot be decoded:
If the SW-D7000U cannot decode a tape that is being Played back, the system will display a blank
screen. The fields will not be decoded or separated.
There are two possible reasons why a tape cannot be decoded:
" The tape was not recorded on a multiplexer, -- or --
" The tape is not compatible with the decoding format selected by the programmer.
In the event that the tape was actually recorded on either a SW-D7000U compatible multiplexer or an
alternate multiplexer, but is not correctly decoded, first check to see that the correct PLAYBACK
FORMAT has been selected in the menus.
To view tapes which were not decoded:
With the VCR Playing back a tape, press FUNCTION (F) then PLAY to view the undecoded input. It
should be clear from the undecoded Playback video if the video is multiplexed or not, as several
camera images will be overlaid on each other.

4.15 COMMUNICATIONS

This option is used to specify the baud rate to be used for the RS-232 serial port and the unit's
network address for RS485 communications.
RS232
RS-232 remote control is through a D-sub 9pin connector on the rear panel. This is used to provide
programmable remote control from a PC or similar controller. The programmer is able to set up all
menu functions and also control front panel controls via the RS-232 port.
Functions included are:
JVC PROFESSIONAL, IMAGING PRODUCTS
JVC
CBR
SL/DM
ROBOT
75