Table of Contents
Advertisement
SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
4.0
MENU PROGRAMMING AND SETUP
This section describes the menu programming features and options for your multiplexer.
NOTE:
The ALARM key and indicator is disabled while the menu system is active.
4.1
INITIAL POWER UP
Once your installation is complete, turn on the power. Your multiplexer will start by displaying the
software version and then a multi-screen display on Monitor-A. If you have previously changed any
settings in the MENU system, your settings are still stored while the power is off and are now current.
Power Up and Tests;
NOTE: Read the entire instruction manual before operating the unit.
"
Power up all the cameras and the monitor, and only then power up the multiplexer by
plugging in the DC 12V class 2 isolated power supply.
"
With the unit in record mode, select each camera, full screen, and check the picture quality.
This is live video. If the picture quality is poor, check the BNC connections and loop-through
terminations, the video levels of incoming signals and potentials for power ground loops.
"
Record/Play quality: Record for at least 3 minutes at normal VCR speed (2 hour mode) and
then play back the recordings, selecting each camera in turn. Check the playback picture
quality.
"
For advice on setting up cameras, consult your camera installation instructions
"
Test the VCR VEXT switch pulse connection to the multiplexer by setting the unit to Record
mode, starting the VCR recording and then changing the VCR record speed on the VCR.
Play back the recording and observe that the unit displays PEXT in the top right corner of
your monitor display.
4.2
USING THE MENU SYSTEM
The SW-D7000U video multiplexer provides programmer-friendly on-screen menus for entry of
programmer data such as titles and for the selection of options. As an alternative to on-screen
programming in the menus, the options can be downloaded via the RS-232 port from a central
controller or PC.
To enter the on-screen program menu, press the MENU key and enter the 4-key
password. The default password is set to 1, 2, 3, 4 when units are shipped from the
factory.
This password can be changed by the programmer in the menus.
The MAIN MENU bar will appear once the correct password has been entered.
Main
42
JVC PROFESSIONAL, IMAGING PRODUCTS
Be sure to check the VCR's tracking adjustment.
QuickInstall
Operator
SystemView
Advertisement
Table of Contents
