Table of Contents
Advertisement
SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
To initiate recording, select MACRO RECORD in the MACRO sub-menu, and select one of the
macros (1-32) on which to start recording.
menus and go to a default screen. Subsequent keystrokes will be recorded into that macro.
NOTE:
An on-screen indicator, 'F' plus the macro number', will appear and will stay on the
screen until recording of that macro is complete.
Each keystroke will be recorded, until either the FUNCTION key and ENTER is
pressed to terminate the macro recording, or until 32 keystrokes have been
recorded.
Special keys functions during MACRO RECORD:
The following two-key combinations provide the programmer with special actions within macros.
FUNCTION then 1
FUNCTION then 2
FUNCTION then 3
FUNCTION then 4
FUNCTION then 5
FUNCTION then 6
FUNCTION then ENTER
Recording new Menu Setups during MACRO RECORD:
If the programmer presses the MENU key during macro recording, recording of
keystrokes is stopped.
programmer only records the final setting of each setup parameter for those sub-menus,
which are accessed by the programmer.
counted as one keystroke in the MACRO.
Upon Playback of the macro, the unit will retrieve only those recorded menu setup parameters, and
will set the unit up accordingly. Parameters in sub-menus, which were not accessed during recording
of the macros, will not be recorded or retrieved during Playback of the macro.
These new menu setups can be activated manually or automatically by time and day (see MACRO
TIMED START) or on Alarm (see ALARM SETUP). Typical uses of this unique MACRO feature are;
"
Different Alarm Associated Alarm Display screens or Alarm Actions
"
"
"
Different sequence tables
"
Different recording modes or playback format
"
"
"
Disable or Enable Cameras, Alarms and Motion Detection
Exceptions to Menu Setup MACRO RECORD:
"
In the Motion Detection sub-menu, motion detection can only be enabled and disabled via
macros. Other motion detection parameters cannot be set via macros
"
The following parameters cannot be set up via a macro, and should be set up during
installation:
#
Output Relay selection, 1 or 2 or both, per input.
#
Output Relay NO or NC selection.
#
'M' indicator ON/OFF selection
#
Video loss relays and buzzer selections, per input
#
VCR switch pulse edge selection
58
JVC PROFESSIONAL, IMAGING PRODUCTS
Upon selection, the system will automatically exit the
Activate output relay 1
Reset output relay 1
PAUSE macro, 1 second
PAUSE macro, 5 seconds
Activate output relay 2
Reset output relay 2
end Macro recording
Instead of recording keystrokes while in the menus, the
Each time the MENU key is pressed it is
Advertisement
Table of Contents
