Table of Contents
Advertisement
SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
mode by using the ALARM key, use the ARROW keys, to go to the first zone to be changed.
"
ENABLE ZONES - is used to change disabled zones to enabled zones.
Enabled zones will sense motion, according to SETUP PARAMETERS. After
selecting ENABLE ZONES mode by using the ALARM key, the flashing cursor
will be changed to the enabled mode (black/white flashing).
ZONES is selected, the ARROW keys move the cursor and enable adjacent
zones. Change the mode to NO ACTION or DISABLE ZONES when no more
adjacent zones need to be enabled.
"
DISABLE ZONES - is used to change enabled zones to disabled zones. Zones
which are disabled will ignore all motion. After selecting DISABLE ZONES mode
by using the ALARM key the flashing cursor will be changed to the disabled
mode (clear/white flashing). Once DISABLE ZONES is selected, use the
ARROW to move the cursor and disable adjacent zones as necessary.
Change the mode to NO ACTION or ENABLE ZONES when no more adjacent
zones need to be changed.
Indications:
To indicate whether each zone is enabled or disabled, enabled zones have a Grey "" indication and
disabled zones have a clear indication inside the corresponding grid position.
SENSITIVITY SCOPE
Your multiplexer includes a helpful graphic representation of motion and the sensitivity settings to
simplify motion detection set-up. You will a "Sensitivity Scope" on the left side lower portion of the
image. This scope represents the sensitivity setting you have selected in RED. A BLACK line that
will move from bottom to top of the scope when movement occurs represents the actual
motion/activity in the scene. When the BLACK line intersects with the RED line, a motion alarm is
activated. In this mode, the sensitivity can be changed by selecting the number keys 1-10. In this
way, the actual motion in the scene can be used to set the most appropriate sensitivity setting.
Exit SETUP ACTIVE ZONES:
When all zones have been set up, the programmer can exit back to the MOTION
DETECTION sub-menu. Press ENTER and all changes will be saved as they were
made.
INDICATE DETECTION
This option in the MOTION DETECTION sub-menu is used to activate the indicator 'M' for motion
detection on Monitor-A. The factory default setting is set to activate the indicator. If you desire the
on-screen indicator not to display when motion is detected then select NO in the sub-menu. This is
a "global" setting and will affect all cameras with enabled motion detection.
If motion has been turned on, but there is no 'M' indication in the corresponding cameras display
when motion is present, check the SETUP ACTIVE ZONES and the sensitivity settings as detailed
below.
ACTIVITY / INTRUSION
The SETUP PARAMETERS for motion detection (sensitivity, target size, false alarm rejection, record
rate, output relays and links to alarm inputs), are chosen on a camera-by-camera basis.
parameters available for each camera in this menu item will depend on whether INTRUSION
DETECTION or ACTIVITY DETECTION is the intended use of that camera.
62
JVC PROFESSIONAL, IMAGING PRODUCTS
Once ENABLE
The
Advertisement
Table of Contents
