Table of Contents
Advertisement
SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
Two internal isolated alarm output relays are provided. Both of these relays can be activated by any
alarm input or by the built-in motion detection sensors. Each input alarm can be programmed to
activate either of the relays, or both relays, or none.
During alarms, the SW-D7000U can automatically adjust the record list so that any cameras in alarm
are recorded at a higher rate. Macro functions, which can execute several pre-recorded keystrokes
automatically, can be activated by any alarm input. Any alarm input can be enabled or disabled.
Alarm Handling Capability:
Alarms can be programmed to:
"
Display Full-screen image of the camera in alarm on Monitor-B.
"
Activate either one or both of the Alarm Output Relays.
"
Latch until reset, Timed-Out (latched for a preset time), or Transparent and follow the status
of the alarm input, either active or not active.
3.4.1
MANUAL ALARM ACTIVATION ( PSEUDO ALARM )
Pressing the ALARM and CAMERA number (of the alarm) key
simultaneously can activate a single camera recording. This will cause the
alarm number corresponding to camera number selected to activate. The
pre-programmed alarm responses will activate automatically through this
manual activation. The programmed parameters for the alarm, such as latching mode, buzzer
setting and relays will determine the alarm actions.
In addition, the camera associated with the alarm will be recorded as programmed.
To deactivate this function, simply reset the alarm as normal by pressing the ALARM key.
3.4.2
ALARM DISPLAYS IN LIVE MODE
During alarms in Live mode, Monitor-A will automatically switch to a full-screen view of the
cameras in alarm. Monitor-B is simultaneously switched full-screen to the camera in alarm.
NOTE:
The alarm screen on Monitor-A will be displayed only while an alarm is active. Once
an alarm times out or is cleared, the display will automatically revert to the screen
displayed before the alarm. It is hence very important that the installer selects the
best alarm-latching mode for alarm displays.
If the operator changes the screen format while an alarm is active, then the unit will continue to
display the operator's selection after the alarm clears - it will not revert to the pre-alarm screen
display.
Monitors A and B Full-Screen during alarms:
During alarms in Live mode, Monitors A and B will automatically switch to a full-screen display of
the camera in alarm. If multiple alarms are active, Monitors A and B will automatically sequence
between the alarm cameras at a fixed 1-second dwell. This dwell is not programmable. Monitor-
B cannot freeze images.
NOTE:
The Monitor-B screen will not revert to its original fixed display after the alarm is
cleared. It will continue to display the last alarm camera.
26
JVC PROFESSIONAL, IMAGING PRODUCTS
However if sequencing
Advertisement
Table of Contents
