Table of Contents
Advertisement
SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
Select any full screen display by pressing the camera number, and then press the
key.
To stop full screen sequencing on Monitor-A:
SEQUENCE
Press
MULTISCREEN
Resolution of Full-screen displays:
The operator can switch the resolution of digital full-screen displays from 'frame' displays to 'field'
displays. The lower resolution 'field' displays can result in less 'flickering' on some high contrast
camera scenes.
FIELD/FRAME SETUP in the OPERATORS menu.
NOTE:
This is a global system setting and all camera displays will be changed.
3.1.4
The operator can easily change the DEFAULT of all camera sequencing by using the AutoList™
function. AutoList™ sequence lists exist for Monitor A, full-screen and Monitor B through E. An
AutoList™ also exists for the PLAY mode. DEFAULT settings for the lists are all cameras
included, dwell time taken from menu. The DEFAULT dwell time is 3 seconds.
An AutoList™ recording is started in full-screen mode (LIVE or PLAY) by
pressing ALARM and SEQUENCE keys simultaneously. Then select
cameras in order of the sequence desired and at time desired for individual
dwell times. Press the SEQUENCE key to stop recording of the AutoList™.
Dwell times of up (time between key presses) to 30 seconds are allowed. A
maximum of 32 cameras may be put into an AutoList™.
Pressing any key other than a valid camera key or the SEQUENCE key during recording will void
the AutoList™. To return to the DEFAULT of all cameras included in the sequence list, with a
fixed menu programmed dwell time, go to the SEQUENCING menu and change the dwell time.
NOTE:
The AutoList™ will be erased whenever the FULLSCREEN DWELL setting is
selected in the SEQUENCE menu.
FULLSCREEN DWELL setting with all cameras consecutively sequenced.
3.1.5
PIP DISPLAY: SIZE AND POSITION
The PIP (picture-in-picture) display on monitor-A can be displayed in one of three sizes, and it
can be displayed in one of two positions.
Size selection:
The sizes can be 1/4, or 1/9 of full-screen.
Position selection:
The PIP can either be displayed on the lower right hand side of the display, or else on the top left-
hand side of the display.
Changing the PIP size and position:
20
JVC PROFESSIONAL, IMAGING PRODUCTS
again, or press any camera key, or press the
key.
Frame resolution is fully interlaced and provides higher resolution.
AUTOLIST™
All Monitor sequences will default to the
SEQUENCE
See
Advertisement
Table of Contents
