Jenn-Air JRTDE228 Use And Care Manual page 7

11. Removethe base grille by grasping at both ends and pulling it straight out.
12. Remove the hinge cover by squeezing both sides together.
13. Use a 5/16" socket and ratchet to remove the two screws from the bottomhinge. Save
the spacer.
"- 14. Pull the metal hinge pin from the sideof the lower hingeand place it, includingthe spacer
washer, into the top hole.
15. Pry out the two screw hole plug buttonson the bottomleft side of the top door and lower
door. Removethe door stops (metal plate) on the bottomof each door and install them
on oppositesides. Press in the plug buttons in the holes on the right side of bothdoors.
16. Set the lowerdoor on the bottom hinge,making sure the hinge pin enters the bushing in
the door bottom.
17. While holding the door in a closed position,take the center hingepin that was removed
in step 3 andinsert it through the left hole of the center hinge andinto the bottom door
bushing. Make sure the long pin goes into the bottomdoor and the short pin goes into
the top door.
18. Set the upper door on the center hinge, making sure the hinge pin enters the door
bushing. When you close the door, the gasket should hold it in place.
19. Makingsure to use the same numberof spacers that were originally used beneaththe
upperhinge, install the hinge mounting screws. Beforetightening these screws, make
sure the top of the door is level with the cabinet top, and the space between the door is
equidistantacrossthe entirefront. Avoidover-tighteningthese screws. Tighten both until
they are just snug, then turn them in another one-halfturn.
20. Examinethedoor gasketall around each door, makingsure no gaps are visible between
the gasket and cabinet. If a gap shows, try stretching the gasketaway from the door so
the magnet will contact the cabinet surface.
21. To replacethe basegrille, line up its springclips with the square openingsin the cabinet
and tap each end in until the gnlle locks in place. Replace hinge cover.
22. Replaceall food and return the fresh food control to its usual operating position.