Installation - Jenn-Air JRTDE228 Use And Care Manual

Installation
Location
If you are installing your new refrigerator yourself, please followthese helpful suggestions.
1. Removebase skids. ._ldl
2. Removeall exteriorand interiortapecarefullyand retainold
tape. Make a small padof this tapeto pickoff any remaining
tape residues. This will eliminate the need to use danger-
ous solvents of any kind.
3. Remove and discard the cantilever shelf packing clips located just above each shelf
wherethey hook onto the frame. To remove the red plastic clip, wiggle it sideways and
pull straight out.
4. Select a locationfor your new refrigeratorawayfrom any heatsources. Allow a free flow
of air throughthe front base grille.
5. Your model should not be installed where the room temperature will go below 55oF.
because it will not run frequently enough to maintain proper temperature in the freezer.
Leveling Is Important
To enhance its appearance,maintain efficient performanceand for properfunction of the ice
maker,your refrigeratorshould be level. Usinga carpenter'slevel, checkyour refrigeratort¢
make sure it is level front to back and side to side. The front wheels were adjusted at the
factory so the cabinet wouldbe level. However,jarring in transit, or standing the refrigerator
on an unevenfloor may cause the cabinet to appear unlevel.
If leveling is necessary, remove the base
grille and adjustthe wheelwith a
screwdriver
_TURN CLOCKWISE TO
as shown. -_- RAISE CABINET CORNER
TOlockthe cabinetin place,turn clown one ,_
or bothlockingfeet, locatednear the front
wheels. Rear levelerfeet are not required.
Ifthefloor is notleveland it isnecessaryto
raise the rear of the cabinet, we suggest TURN COUNTER-CLOCKWISE
rollingthe rear wheels on to a piece of TOLOWER CABINET CORNER
plywood or othershimmaterial.