Table of Contents
Advertisement
Verify the input with the enter key.
The cursor jumps to selection of loading point (LP: AUT).
Select manual input of loading point, for example, by pressing the plus key.
(LP: MAN).
Verify input with the enter key.
Input the setting for the loading point according to the length of the guide blade in use
(e.g. LOADING POINT: 155).
Verify input with the enter key.
The cursor jumps to input of the starting point (STARTING POINT: 0).
Input the setting for the starting point, e.g. 0.
Verify input with the enter key.
Depending on the required seam pattern, start- and finish backtacks, stitch condensation
at beginning and end of seam, angle seams, basting seams and n can be input using the
corresponding function keys.
10
Examples of how to make up seams
.06
In the following a number of examples are given to explain how to input seams for different
applications.
10
Single-pointed darts
.06.01
Basic guide blade size: 155 x 10 mm (length x depth).
The guide blade can be used for different dart shapes and sizes. To achieve this, the depth
of the guide blade must be suitable for the smallest dart depth, and its length for the
longest dart length.
Max. dart length
Min. dart depth
Max. dart depth
= length of guide blade (here, e.g.: 155 mm)
= depth of guide blade + 1.5 mm (here: 11.5 mm)
= depth of guide blade + 1.5 mm + 40 mm (here: 51.5 mm)
Programming
10 - 12
Advertisement
Table of Contents
