Table of Contents
Advertisement
10
Making waistband pleats
.06.03
Fig. 10 - 09
Select the INPUT mode.
Press the seam input key (diode lights up)
Input the required program number.
Input the seam length, e.g. 35 mm (Fig. 10-09).
Input the stitch length.
Set the loading point at manual input
Input the loading point.
Input the starting point
Input a start backtack
Input stitch condensation at the end of seam.
Input the enaging depth, e.g. 10 mm (for a 20 mm deep dart with a 10 mm deep guide
blade, see Fig. 10-09.
Input the angle seam length, e.g. 30 mm (Fig. 10-09).
Input the angle seam depth according to the preset amount, here 20 mm.
Specify the setting for the angle, e.g. accept preset amount by pressing enter
key (Fig. 10-09), or:
Increase the amount of the angle (Fig. 10-10).
The input seam pattern is accepted by selecting the SEWING mode.
35 mm
30 mm
A backtack at the seam end is only practical if the seam does not end outside
the material (e.g. as on straight pleats).
To input a curved seam line the preset angle must be increased considerably
(seam test required).
Fig. 10 - 10
Programming
10 - 16
Advertisement
Table of Contents
