Examples For Seam Programming; Example For Seam Program Input - Pfaff 1571 Instruction Manual

11

Examples for seam programming

.05
In the following, examples are shown of the procedure for creating seam programs via the
seam program input, as well as the teach-in function.
11

Example for seam program input

.05.01
The seam to be programmed should
- contain 5 seam zones
- and be saved under program number 7
 Switch the machine on
 Press the TE/Speed key twice to call up the input mode (LED lamp lights up).
2 x
 Press the PM key to call up the seam program input (LED lamp lights up).
 Enter the template code, see chapter 9.09 Entering/changing the template code.
 Select the program number "7" by pressing the corresponding +/- key.
Confi rm this selection by pressing the corresponding +/- key.
 The display switches to enter seam zone one.
The programming examples shown in the display are only as follows, when no
seam program has been entered under the selected program number.
2.5 2.5
NO VAL
101
P
7
II
Input
61