Before Use; Steam Ironing - Binatone SI-4060 Instruction Manual

! Remove all packaging from the appliance.
! Turn the steam control knob (9) and the tem-
! If you intend to iron with spray or steam, push
Note: If your area has hard water, we recommend you use
cold boiled water.
Attention: Always disconnect the iron from the electricity
mains supply prior to filling the tank (5). Do not
overfill the tank (see the «Max» mark on the tank
(5). Do not fill the tank (5) with other liquids.
! Prior to first use iron a clean old piece of cotton cloth to make
sure the sole plate and the water tank are absolutely clean
(see subsection «Steam ironing»).
Note: Light smoke may emit during the first use of the
appliance: it is a normal occurrence that will soon
disappear.
INSTRUCTIONS FOR USE
1. Place the iron into a vertical position.
2. Insert the power plug (13) into the mains
3. Turn the temperature control knob (10) to
Note: In case the manufacturer's recommendations are
missing, select the temperature setting, which
corresponds to the type of the cloth to be ironed (see
section «Useful advice»).
4. The operation indicator (11) will light up to indicate that the
iron is being heated to the set temperature level. When the set
temperature level is reached, the light indicator (11) will turn
off.
Note: During operation of the appliance the light indicator
will light up and turn off periodically; this is normal
and not a malfunction.
Dry ironing can be can be used at any temperature setting. To
do this the steam control knob (9) must be put into the «0» posi-
tion. If you intend to use the steam function, allow the iron to heat

BEFORE USE

perature control knob into the «0» position.
the cover (4) up and fill the tank (5) with
water through the opening (3). Use the mea-
suring jug (15) for convenience and ease.
supply outlet.
set the temperature recommended by the
manufacturer of the textile article (usually
indicated on the article's label).

Steam ironing

6